How to Set Up Your Carl’s Place DIY Golf Enclosure Package (Step-by-Step Guide)

So, you’ve just ordered your Carl’s Place DIY Golf Enclosure Package from PlayBetter.com — congrats! You're one step closer to having an epic golf simulator setup at home. While the full instruction manual and video guide are your go-to resources, we’ve created this post to walk you through the essential steps—so you can get up and running faster and with fewer headaches.

👉 Before You Begin

Make sure you have:

• Your full enclosure kit (pipes, fittings, screen, nylon enclosure, ball bungees, foam inserts, etc.)

• A large enough space cleared (check your enclosure size specs!)

• A helper—some steps are easier with two people

• A rubber mallet, step ladder, and measuring tape

Instruction PDFs & Walk-Thru Video

We recommend using the instruction manual and video guide as your go-to resources during the build process.

Step 1: Build the Frame

🧱 Start with the base: Lay out your frame using the labeled pipe sections. Use the corner and T-connectors to assemble the floor rectangle. This creates the footprint of your enclosure.

📏 Go vertical: Add the upright poles to each corner. Then connect the top frame across the ceiling. This is what gives your enclosure its full 3D structure.

🔧 Tip: Use a rubber mallet to firmly insert pipes into connectors—don’t be shy! A snug fit is key to stability.

Step 2: Attach the Impact Screen

🪝 Align the screen: Center your impact screen across the front of the frame. Make sure the hook-and-loop side is facing out if you’re using optional foam inserts later.

💥 Secure with bungees: Use the included ball bungees to attach the screen to the frame. Start at the corners and work your way around to maintain even tension.

📌 Pro Tip: You want the screen taut—but not over-tight. There should be just enough give to absorb impact without causing bounceback.

Step 3: Add the Nylon Enclosure Panels

🖤 Side & top panels: The black nylon enclosure attaches to the frame via hook-and-loop strips. Drape the panels over the top bar and secure down each side.

🔒 Seal the corners: Fasten the corner seams using the integrated hook-and-loop sections to create a tight, seamless look.

💡 Lighting note: The black nylon helps absorb ambient light, improving your projector’s image quality.

Step 4: Optional Add-ons (Highly Recommended)

🧩 Foam Insert Kit: Slides 18–20 in this presentation show how to install foam panels around the screen edges. These reduce ball rebound and give your enclosure a clean, finished look.

🛡️ Back Cover Kit: Want a fully enclosed setup? Add the back cover and back piping for a polished, immersive environment (especially useful in bright spaces).

Step 5: Final Checks

✅ Make sure:

• All fittings are snug and aligned

• The screen has even tension

• The enclosure nylon is smooth and secure

• Optional accessories are in place

🎯 Now you're ready to set up your launch monitor, projector, and hitting mat!

Video Walkthrough

Want to follow along with a visual guide? Watch this detailed Carl’s Place setup video for an excellent reference during your install.

Need Help?

If you're stuck or need advice on getting the most from your Carl’s Place setup, our team is here to help. Just reach out to us or use the live chat on our site.

Let the swings begin.
You just built a golf simulator you’ll use all year long—and it’s going to be awesome.